How do you change a throttle cable on a lawn mower

Remove the cable housings using a pair of pliers. … Thread the cable wire through the housing. … Slide the cable through the housing and then into the handle unit to attach it to the throttle handle. … Test the tension by replacing the throttle.

How do you install a throttle cable on a lawn mower?

Remove the cable housings using a pair of pliers. …
Thread the cable wire through the housing. …
Slide the cable through the housing and then into the handle unit to attach it to the throttle handle. …
Test the tension by replacing the throttle.

What is a throttle cable on a lawn mower?

Your lawn mower’s throttle cable controls the machine’s engine. It’s the part that kick-starts the engine and commands the speed of your mower’s blades. If the engine dies down or the mower doesn’t respond to adjustments in the throttle handle, you may want to troubleshoot the throttle cable.

How do you fix a throttle on a lawn mower?

Step 1: Remove the faulty throttle cable.
Step 2: Place the new cable on the handle.
Step 3: Connect the new cable.
Step 4: Adjust the new cable. Check if your mower is always idle or running at high speed with the new cable. …
Step 5: A test drive.

How much does it cost to replace a throttle cable?

How much does an accelerator cable cost? It’s not that hard of a job, most of the cost is in labor. Expect prices to start at $165 and go higher than $300.

What do I do if my throttle is stuck?

Keep calm. Take a deep breath. …
Shift to neutral. The key is to shift into neutral when you have a stuck accelerator. …
Put on your hazard lights. …
Apply the brakes. …
Navigate the car to the side or off the road to safety. …
Inspect your pedals. …
Call for help.

What happens if the throttle cable breaks?

If the cable breaks, or comes out of adjustment far enough, it can affect the drivability of the vehicle to the point where the car will not be drivable until the problem is addressed.

How long does a throttle cable last?

How long you can expect your accelerator cable to last will depend in large measure on how often you drive. The more use the accelerator cable gets, the more prone it is to wear and tear. Usually, you can expect to get five years from your accelerator cable before it needs to be replaced.

How do I know if my throttle cable is bad?

Common signs include damage to the outer covering, delayed accelerator response time, and problems with cruise control.

What is the most common cause of a stuck accelerator?

A mat or carpet blocking the travel of the pedal is the most common reason.

Article first time published on

Why is my throttle cable stuck?

A sticky throttle could be caused by worn cables, lack of lubrication in the cables or the cable getting bound up somewhere in the mechanism. Or it can be caused by an issue with the carburetor or EFI. … If the screws in the throttle housing are too tight it could cause the cable to stick.

How do you adjust the throttle cable on a Briggs and Stratton lawn mower?

Adjust the throttle lever to the “Fast” or “High” setting. Loosen the screw that holds the mounting bracket that supports the cable with a flat-head screwdriver. Loosen it just enough to allow the cable to move through the support freely.

How do you fix a stuck choke cable?

Pour penetrating oil into the cable (Photo 1). Grab the inner cable with pliers and work it up and down to loosen it. When the cable moves freely and all the penetrating oil has drained out, squirt silicone lubricant into the funnel to keep the cable sliding freely. Reinstall the cable (Photo 2).