How do you remove T bar fence posts

Position a garden hose to be running into the ground where the T-post is. While water flows freely into the post hole, start rocking the T-post back and forth. You will continue this motion until the ground loosens around the T-post and you can pull it free.

How do you pull out T posts?

Position a garden hose to be running into the ground where the T-post is. While water flows freely into the post hole, start rocking the T-post back and forth. You will continue this motion until the ground loosens around the T-post and you can pull it free.

What is post puller?

SpeeCo S16110400 Metal T-Post Puller; Allows the T Post To Be Removed From the Ground with a Tractor Bucket, Chain, Handyman Jack or a S Hook; Allows the Use of Different Gauges of Chain; Easy and Quick To Use.

How do you remove a fence post without a jack?

If you don’t have scrap lumber, you can use a spade bit to drill a hole in the side of the post, large enough to insert the pry bar and get leverage. Another option is to drill a hole clean through the post, with a diameter big enough to slide your bar through.

How do you pull a post with a skid steer?

With bucket rolled in the dump position, lower over top of post and roll bucket to pinch top of post and raise loader. This pinch system could be a pipe welded between rear pins so you can see to slip over top of post from tractor. Pull post, roll bucket to release, all without getting off tractor.

How do you use a post puller plate?

Place a chain hook through the chain hole or loop. Place the T-Post Puller around the t post, and pull the t post out. No more chain slipping off or wrapping the chain around the t posts every time. Simply slide around the t post post and pull up.

How do you remove a wrought iron fence?

1. Locate the bolts attaching the wrought iron fence section to the support post. …
2. Loosen the bolts attaching the fence section to the support post on each end of the section with a socket wrench. …
3. Remove the bottom bolts on each end of the fence section completely.

How do you remove a metal fence post from concrete?

If your metal posts have been set in buried concrete, it’s best to pull the concrete out with the each post, and with mechanical help, you can avoid excessive digging. Drill a 1/2-inch hole through each post — about 4 inches above the ground — and insert a length of 3/8-inch re-bar to provide a grip.