How do you remove transport bolts from a washing machine

Failure to remove the shipping bolts and retainers before use may cause severe vibration and noise, which can lead to permanent damage to the washer. The second possible cause of excessive vibration is a shipping block that might be caught under the washer.

What happens if you don't remove shipping bolts from washing machine?

Failure to remove the shipping bolts and retainers before use may cause severe vibration and noise, which can lead to permanent damage to the washer. The second possible cause of excessive vibration is a shipping block that might be caught under the washer.

What happens if you use a washing machine with the transit bolts still in?

If transit bolts have not been removed, the machine will sense this and refuse to run. It may sound alarm beeps. If there are no such sensors or damages, the motor may force to rotate the drum. This may cause a severe damage, motor burnout, etc.

Do you have to remove transport bolts from washing machine?

Moving a washing machine without transit bolts will run the serious risk of damaging your machine, so we strongly advise against it. … However, you must remember to remove the transit bolts once your move is complete, as they can seriously damage your machine should you begin a wash cycle with them still in place.

How do you transport a top loader washing machine?

The safest way to move a washer is by transporting it in an upright position. Due to the height and awkward shape of most washing machines, a dolly is recommended to get your washing machine off the ground and through any obstacles, be they a flight of stairs or up inside a truck.

Why do washing machines have transit bolts?

A transit bolt, also called a washer shipping bolt, is installed through the back a washing machine to keep the tub from moving around during shipping. … In many cases when the washer was delivered and set up, the delivery crew will give you the bolts once they have been removed from the washer.

Do all new washing machines have transit bolts?

Normally when you get your new washing machine there will be two (rare), three or four transit bolts fitted through the rear panel of the washing machine that fix to the outer tank of the washing machine. … These bolts must be removed before the washing machine is used.

Can you transport a top loading washing machine on its side?

It’s recommended you always keep a washing machine in an upright position. Laying a washer on its side can cause the inner and outer tubs to bump against each other, which can loosen support pads or damage the suspension. It can also cause the tubs to move out of alignment and alter the way your unit works.

Can I transport a washing machine laying down?

Yes you can. But take precautions lest you damage the WM. Like a refrigerator (also a household equipment), it’s recommended you move a washing machine stood upright. If extreme conditions don’t permit, transport it laid on either of the sides which don’t have protruding water pipes.

Can you lay a washer on its back to transport?

Also, make sure your washer is placed in the moving van upright. Shipping your washer on its side, front, or back can damage it. When you install your washer in your new home, most likely you will have to level and balance it. Also, make sure you take out the shipping bolts before using the washer at your new location.

Article first time published on

How many transit bolts does a Haier washing machine have?

Step 2: Remove the transportation bolts from the back of the machine. Note :There are normally 4 bolts, but some models have only 3 bolt. Step 3: Refit the rear cover.

Do Bosch washing machines have transit bolts?

All new washing machines are fitted with a transit bolts to protect the machine against damage in transit. Transit locks and bolts must be removed before you use your appliance.

How do I remove polystyrene from under my washing machine?

Locate the ribbon at the bottom of the washing machine, this will usually be attached to a sticker. Carefully tilt the washing machine back and pull the ribbon to release the piece of Styrofoam from underneath the washing machine then carefully replace the washing machine to its standing position.